Forum: FragTag

As I'm in the market to start a combat sports business I'm researching all of my options including the diy route. Having been to the Frag tag site,...

Hi Builty I have a question regarding the alternating fire config in single barrel mode.In the Fragtag Mainboard Manual it says the secondary...

Proteus, Mainboard, and Odin firmware versions 3.20 now released. Changes: - Proteus only: fixed some sound issues - All: support for new...

Hiya Builty Have you got a release date on the new FragTag Magazines ? I was planning on doing some gun building towards the end of next month and...

Some new updates have been released today: Mainboard and Proteus firmware 3.13 Minor tweaks and fixes, no compatiblity changes. Changes: -...

Hi Builty, any luck that you have fixed the date to released the assembled taggers? My partners and I are very interested in getting a number over...

We now have stocks of a new iButton port, suitable for use with our V3 Simulation accessories. Machined from metal, it's more robust than other...

We've just launched our new web site, same address as before (http://www.fragtag.com.au) It incorporates a new shopping cart system that should...

We’ve just released our new “HQ-SFX” sound effect module. It’s a drop in replacement for the obsolete ISD2560 sound chip, and offers 50% longer sound...

Looking at attaching a gun sensor, (no led) so wires would be power ground and data, anyone done this previously mardad

FragTag system level V3 is launched today. Release Notes: http://www.fragtag.com.au/release_notes_v3.html Upgrades:...

We're holding a photo contest, to put on the banner of our web site, replacing the dude with the moe and the M4. Prize: 1 HQ-SFX sound module,...

I have LCT Predator Taggers and would like to fit them with ibuttons, the connector where this should go is currently connected to the scope. Does...

Guys, I'm assuming (hoping) you wire up the premade head sensors all the same. I did a bit of a DIY modification on the termination, and managed...

Hey guys as you can tell I'm relatively new to this arena of forum warfare :D Myself and a group of others have been recently looking into...

Will the fragtag accept input from the new Lithium Polymer batteries? (ie will the fragtag board accept an input volatge of 7.4v instead of the...

FragTag system level V3 is now 99% coded, just one little bit to go, then its time for extensive testing for quality assurance. On track for end of...

Here's a pic of our new sensor housings that we have in development. They are made on the vacuum forming machine, from a particular IR filter plastic...

Wasn't sure whether to post this in the Drawing Board area or FragTag. Here seemed the most logical. Looking at building a Fragtag tagger. ...

We're about to build a few more taggers so started looking at parts. Farnell now list two TSAL6100 LEDs with different specs. Both are: 950nm,...